This time I'm going to teach you how to make an rc airplane very easy, but you'll need some time and dedication to complete ...

5V, GND (2 pin) 2x CAN for debug (1 for each interface) (4 pin) RGB LED (3 GPIO to control) (3 pin) I/O (11 pin) 15x RC-Servo output: connecteur 3pin 2.54mm standard (+,-,signal). use PWM if available ...

This time I'll make an rc racing boat made out of foam board. This boat is capable of reaching high speeds, in this video, you'll see the entire process and the struggle of building something I don't ...

Includes 20 Sets in one box. including connector housing, protective housing and male and female crimping pin.Easy to store Circuits: 3 Pin spacing: 2.54mm Material: brass and nickle plated. Low ...

It's based on the ATmega 328 version: https://github.com/TheDIYGuy999/Rc_Engine_Sound and on bitlunis Halloween example: https://github.com/bitluni/MotionPumpkin ...

Conventional stud connectors were proved to be inconvenient for the later disassembly and replacement in ultra-high performance concrete (UHPC) bridge decks. In this study, the headless studs which is ...

While building robotics projects, the importance of controllers and motors cannot be overstated. These components are the heart and soul of any robotic system, providing the necessary control and ...

Abstract: This paper concerns compliance motion control for joints of a humanoid robot for the external force. Our strategy is to estimate the amount of the external force by measuring the motor drive ...

If this is your first tie facing these mechanisms you’re in for a little bit of confusion. Don’t worry. That’s natural. It is not something you can grasp on the first try. That’s why we are here.